ONTAP MetroCluster FC Installation 9.8
Kursun kodu
NEP_OT-MCLU-FC-I9.8
Müddət
2 Gün, 16 Saat
Kursun təsviri
Məqsədlər
Tələblər
Kursun proqramı
Kursun təsviri
NetApp® MetroCluster software is a unique high-availability and disaster-recovery solution. In this course you learn how to cable and set up a MetroCluster environment. Using active, participatory exercises, you practice the configuration and verification steps. You also learn how to identify component failures and practice recovery steps.
Test and Certification
This course supports the NetApp Certified Implementation Engineer – Data Protection Specialist certification (NCIE)
Training units: 24
Məqsədlər
This course focuses on enabling you to do the following:
- Describe the major architectural components of a MetroCluster environment
- Cable nodes, back-end FC switches, and FibreBridge devices
- Set up bridges and back-end FC switches
- Configure the clusters at both sites in a MetroCluster environment
- Set up a MetroCluster configuration and serve data to clients
- Detect and recover from failures in a MetroCluster environment
- Install and configure NetApp MetroCluster TieBreaker software
Tələblər
Prerequisites
- Basic SAN knowledge
- Completion of an ONTAP Professional Compliance Program or equivalent
Audience
- NetApp Employees
- Partner Professional Service Implementation Engineers
- Customers
Kursun proqramı
Module 1: Overview of MetroCluster
Introduction to MetroCluster software
Supported configurations
Implementation steps
Configuration tools and documentation
Module 2: MetroCluster Cabling
Disk requirements
Cabling overview
Controller cabling
Switch cabling
Module 3: Bridge and Switch Configuration
ATTO FibreBridge configuration
Brocade FC switch configuration
IOD and OOD delivery
Module 4: Cluster Configuration
Disk assignment
Cluster setup
Module 5: MetroCluster Configuration
Setup
Verification
Monitoring
SVM configuration
Module 6: Failure Scenarios
Switchover
Switchback
Failure scenarios
LIF placement
Module 7: TieBreaker Configuration
Introduction to TieBreaker
Installation
Configuration
Ən yaxın kurs üçün qeydiyyat
ONTAP MetroCluster FC Installation 9.8
Kursun kodu:
NEP_OT-MCLU-FC-I9.8
Müddət:
2 Gün, 16 Saat
